4.6 Post-installation activities

After installing a new application you will normally want to read any documentation it may have included, edit any configuration files that are required, ensure that the application starts at boot time (if it is a daemon), and so on.

The exact steps you need to take to configure each application will obviously be different. However, if you have just installed a new application and are wondering ``What now?'' these tips might help:

• Use pkg_info to find out which files were installed, and where. For example, if you have just installed FooPackage version 1.0.0, then this command :

      # pkg_info -L foopackage-1.0.0 | less
  

  will show all the files installed by the package. Pay special attention to files in man/ directories, which will be manual pages, etc/ directories, which will be configuration files, and doc/, which will be more comprehensive documentation.

  If you are not sure which version of the application was just installed, a command like this

      # pkg_info | grep foopackage
  

  will find all the installed packages that have foopackage in the package name. Replace foopackage in your command line as necessary.

• Once you have identified where the application's manual pages have been installed, review them using man. Similarly, look over the sample configuration files, and any additional documentation that may have been provided.

• If the application has a web site, check it for additional documentation, frequently asked questions, and so forth. If you are not sure of the web site address it may be listed in the output from

      # pkg_info foopackage-1.0.0
  

  A WWW: line, if present, should provide a URL for the application's web site.

This, and other documents, can be downloaded from MicroBSD.

For questions about MicroBSD, read the documentation before contacting <MicroBSD Support>.
Copyright © 1995-2003 by The FreeBSD Documentation Project, OpenBSD FAQ Copyright © 1998-2003 OpenBSD, Modified for MicroBSD